This weeks challenge at 'Simon says stamp and show' called Rustification has been especially inspiring for me!
A few months ago I rusted some nuts and bolts/washers/tiny screws etc, but didn't get around to using them.So this was the perfect excuse! They seemed to have rusted even further while in storage too (Which I am not complaining about one little bit ;)
![]()
These were rusted over a weekend. Dipping them into coke (Yep.. coke! Makes you wonder what it does to your insides eh) dipping them for about an hour or two, then leaving them to air dry outside for another few hours. I repeated this about 5 times.
![]()
![]()
![]()
![]()
![]()
![]()
![]()
![]()
iz x
A few months ago I rusted some nuts and bolts/washers/tiny screws etc, but didn't get around to using them.So this was the perfect excuse! They seemed to have rusted even further while in storage too (Which I am not complaining about one little bit ;)
These were rusted over a weekend. Dipping them into coke (Yep.. coke! Makes you wonder what it does to your insides eh) dipping them for about an hour or two, then leaving them to air dry outside for another few hours. I repeated this about 5 times.
I also had a tin case I have been wanting to alter for a while..
Here are the beginnings of my altered tin case. I covered it all with tin foil, and made a raised frame on the tins lid, so i could put all of the rusty bits and pieces inside. Made a frame too, with the intention of making something which matched to go inside.
Many coats of paint later, with all the rusty bits inside the frame... I decided to experiment with the PVA glue, and poured a load into the frame. It was approx 80% PVA and 20% water.
It took a while.. but 3 days later it was finally dry :)
I added a cage type grill to the front, so it gives the illusion that you can see into the tin, and its full of rusty nuts and bolts etc.
With the tiny frame, I hand painted a spooky image. Inside the tin I lined it with some lush fabric, and added some tiny sea shells and little charms.
As always, I enjoyed making this :)
